Tuesday 10 February 2009

Speed signs

Cotham Councillor Neil Harrison has apparently reported that the Cotham-Road speed warning sign was not working. One question: how exactly do you note that it is not working? Very few experiments spring to mind
1. Drive down the road at 35 mph or higher and see if you get told off by the sign
2. Put a speed camera up and see if any vehicles are speeding but while the sign stays unlit.
If the camera actually counted vehicles/day and illuminations/day, then we'd have an interesting data source for traffic volumes and the percentage speeding- and you'd have an easy way to detect failure. But sadly, this is not a feature of these signs, which is a pity. It would then be of datamining value, rather than just decoration.

Now that the sign is apparently fixed, we need a test for that too. Again, the test is simple: drive down the road fast. In a five minute period on Saturday afternoon, 30% of the passing cars appeared to be participating in this test, which shows how much they care about signs working.

Here, for example, is the Audi A055GEY, showing that whatever speed it was doing, it was enough for the light to come on

A lull in traffic provides enough time for some pedestrians to cross. This crossing here is the main crossing point to any schoolkids going to the nursery school on the right-hand-side of the road (mostly from cars temporarily parked in the buses-only parking on the LHS), and for secondary school-age kids going to Cotham Grammar across the road.

With the school rebuilding going on, there is likely to be more pedestrian traffic here. Hopefully the 30 mph sign and a flashing 20mph sign on weekday mornings is enough to ensure safe crossings. That is if the sign works.

Again, a car volunteers to check the sign lights. It's not quite so obvious from the camera angle, but whatever speed it is calibrated too, it has been triggered by a Peugeot.

A period with the sign off would actually be a good basis for a "do these signs actually work" experiment. Turn it off for a month, measure traffic volume and average/peak speeds. Turn it on again, measure the same numbers. See if it has any effect whatsoever.

Correction: The first post called the councillor Neil Hamilton, who was in fact the Conservative-cash-in-an-envelope MP for Harrods; Neil Harrison is the LibDem councillor for Cotham. He says he determined the sign wasnt working it by watching it for 15 minutes as cars went past, and noticing that it never went on. Yes, that would work.

6 comments:

  1. these signs will illuminate even if you are traveling under 30mph.

    ReplyDelete
  2. As Gareth said, these signs are hopelessly inaccurate. I have calibrated my speedometer using a good GPSr and can always trigger the ones on Cribbs Causeway, Southmad Road and Passage Road at or below the set speeds.

    ReplyDelete
  3. These ones are fairly well calibrated. The ones in lockleaze, they are set to something like 20mph and everyone ignores them.

    Good idea, checking with GPS. Will have to try that.

    ReplyDelete
  4. Actually, I happened to be standing next to the sign for about 15 mins and in that time a couple of cars sped past at obviously over 30mph.

    As I understand it, the technology of speed-activated devices is much less reliable at lower speeds. This is why 20mph limits can't be enforced by cameras. And presumably why some people under 30mph set off the one on Cotham Road.

    There is good evidence that this type of sign does lower average speeds, though clearly not everyone takes notice. I am looking at whether one is possible on Hampton Road, following concerns about speeding from residents.

    ReplyDelete
  5. The one in Redland Road has never worked! AFAICT.

    ReplyDelete
  6. You're right about the Redland Road one - I've called that in now too. Begs the question of whether there is a maintenance issue here.

    ReplyDelete

Commenters MUST NOT post spam, MUST NOT post requests for cross linking and MUST NOT post up requests for paid links. Such attempts SHALL result in one or more postings in which we MAY be rude or we MAY make fun of you and MAY include your public email address. Furthermore, we MAY report you to google for attempts at paid linking, who SHALL then punish your site.

Comments are closed after two days -after that they are moderated. You MUST be logged in to post.

This statement follows RFC2119 rules regarding the use of MUST, MUST NOT, MAY, and SHALL and MUST be treated as normative.